Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra di ata750ef citransm
<< Back | HomeMost service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.
Image preview - the first page of the document
>> Download citransm documenatation <<
Text preview - extract from the document
DI-1105
DIAGNOSTICS - AUTOMATIC TRANSMISSION (A750E for 1GR-FE)
DIDVU-01
Shift Position L Switch Circuit
CIRCUIT DESCRIPTION
The shift position L switch is a momentary type switch. When the shift position L switch is pressed while
driving with the shift lever in the 2 position, the L position indicator on the combination meter comes on and
the transmission is locked in 1st gear. When the switch is pressed again, the indicator goes off and the trans-
mission is released.
WIRING DIAGRAM
ECM
Integration Control and Panel
17 9
V-W
LMS I24 E4 LMS
10
W-B
I25 E
A
J13
J/C
II
D14233
DI-1106
DIAGNOSTICS - AUTOMATIC TRANSMISSION (A750E for 1GR-FE)
INSPECTION PROCEDURE
1 Check harness and connector (shift position L switch - body ground).
Wire Harness Side: PREPARATION:
(Connector Front View): Remove the center cluster integration panel assembly (shift
position L switch).
I25 CHECK:
Measure the resistance according to the value(s) in the table
below.
OK:
Tester Connection Specified Condition
D14179 10 - Body ground Below 1
NG Repair or replace the harness or connector
(See page IN-30).
OK
2 Inspect center cluster integration panel (shift position L switch).
CHECK:
Measure the resistance according to the value(s) in the table
below.
OK:
Switch Condition Tester Connection Specified Condition
Shift position L switch I24 - 17 (LMS) -
Below 1
pressed and held I25 - 10 (E)
Shift position L switch
10 k or higher
released
I25 I24
E
LMS
D13886
NG Replace center cluster integration panel
(shift position L switch).
OK
DI-1107
DIAGNOSTICS - AUTOMATIC TRANSMISSION (A750E for 1GR-FE)
3 Check harness and connector (shift position L switch - ECM).
ECM: PREPARATION:
E7 E6 E5 E4 E3 (a) Install the center cluster integration panel assembly (shift
position L switch).
(b) Disconnect the connector from the ECM.
CHECK:
Measure the resistance according to the value(s) in the table
below.
LMS OK:
D14184 Switch Condition Tester Connection Specified Condition
Shift position L switch E4 - 9 (LMS) -
Below 1
pressed and held Body ground
Shift position L switch
10 k or higher
released
NG Repair or replace the harness or connector
(See page IN-30).
OK
Proceed to next circuit inspection shown on
matrix chart (See page DI-971).
◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo