Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra mtra60 outsha insp

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download insp documenatation <<

Text preview - extract from the document

MT-46
        MANUAL TRANSMISSION (RA60)   -   OUTPUT SHAFT
                                                                                        MT0I0-01


                            INSPECTION
                            1.     INSPECT OUTPUT SHAFT
                            Using a cylinder gauge, measure the inside diameter of the out-
                            put shaft.
                                   Standard inside diameter:
                                   45.009 to 45.025 mm (1.7720 to 1.7726 in.)
                                   Maximum inside diameter:
                                   45.025 mm (1.7726 in.)
                   D14079
                            If the diameter exceeds the maximum, replace the output shaft.

                            2.     INSPECT SYNCHRONIZER RING
                            (a)    Using a feeler gauge, measure the clearance between
                                   the synchronizer ring and the gear spline.
                                   Standard clearance:
                                   0.70 to 1.50 mm (0.0276 to 0.0591 in.)
                                   Minimum clearance:
                                   0.70 mm (0.0276 in.)
                            If the clearance is less than the minimum, replace the synchro-
                   D13974   nizer ring.

                            (b)   Coat the output shaft and synchronizer ring cone with
                                  gear oil. Check the braking effect of the synchronizer ring.
                                  Turn the synchronizer ring in one direction while pushing
                                  it against the gear cone. Check that the ring locks.




                   D13975

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo