Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra sa fds reas

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document
reas

>> Download reas documenatation <<

Text preview - extract from the document

SA-32
SUSPENSION AND AXLE - FRONT DRIVE SHAFT
SA1K3-02

REASSEMBLY
1. INSTALL DUST COVER
Using a screwdriver and hammer, install a new dust cover.
2. INSTALL DUST SEAL
Using a screwdriver and hammer, install a new dust seal.

F06649

Inboard Joint Boot Outboard Joint Boot 3. TEMPORARILY INSTALL OUTBOARD AND INBOARD
JOINT BOOTS AND NEW BOOT CLAMPS
HINT:
S Before installing the boots, wrap the spline of the out-
board joint shaft with vinyl tape to prevent the boots from
being damaged.
S Before installing the boots, place 3 new clamps to the
small boot ends and large boot end (outboard joint side).
Vinyl Tape W03195

4. INSTALL INBOARD JOINT SHAFT TO OUTBOARD
JOINT SHAFT
Align the matchmarks placed before disassembly, and using a
snap ring expander, put in the inboard joint shaft while expand-
ing the snap ring.
5. INSTALL BOOT TO OUTBOARD JOINT
Before assembling the boot, pack the outboard joint and boot
Matchmarks with grease in the boot kit.
W03218 Grease capacity (Color = Black):
205 - 225 g (7.23 - 7.94 oz.)
6. INSTALL BOOT TO INBOARD JOINT SHAFT
(a) Pack the inboard joint and boot with grease in the boot kit.
Grease capacity (Color = Black):
190 - 210 g (6.70 - 7.41 oz.)
(b) Temporarily install the boot to the inboard joint shaft.

7. CHECK DRIVE SHAFT LENGTH
(a) Make sure that the 2 boots are on the shaft groove.
(b) Make sure that the 2 boots are not stretched or contracted
when the drive shaft is at standard length.
Drive shaft standard length:
523.5

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo