Service Manuals, User Guides, Schematic Diagrams or docs for : . Car Manuals Toyota Tundra 2000-2006 Approved 04-06 techinfo.toyota.com ileaf 06toyrm 06toypdf 06rmsrc 06tundra sr stewhe reppro

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.

Image preview - the first page of the document
reppro

>> Download reppro documenatation <<

Text preview - extract from the document

SR-10
STEERING - STEERING WHEEL
SR1HN-03

REPAIR PROCEDURES
HINT:
This is the repair procedure for steering off center.

1. INSPECT STEERING WHEEL OFF CENTER
Steering Wheel (a) Apply masking tape on the top center of the steering
wheel and steering column upper cover.
Masking Tape

Steering Column
Upper Cover

F16015

(b) Drive the vehicle in a straight line for 100 meters at a
Steering Column constant speed of 35 mph (56 km/h), and hold the steer-
Upper Cover
ing wheel to maintain the course.
Masking
Marked Line Tape (c) Draw a line on the masking tape as shown in the illustra-
Steering tion.
Wheel

F16016
SR-11
STEERING - STEERING WHEEL

(d) Turn the steering wheel to its straight position.
Steering Column HINT:
Upper Cover
Refer to the upper surface of the steering wheel, steering spoke
New Marked and SRS airbag line for the straight position.
Line
(e) Draw a new line on the masking tape of the steering wheel
Steering Wheel
as shown in the illustration.
(f) Measure the distance between the 2 lines on the masking
tape of the steering wheel.
(g) Convert the measured distance to steering angle.
Measured distance 1 mm (0.04 in.) = Steering angle
approximately 1 deg.
HINT:
Make a note of the steering angle.
F16017 2. ADJUST STEERING ANGLE
(a) Lift up the vehicle.
NOTICE:
The adjustment method for steering angle is different de-
pending on the models. Check whether it is type A or B.
(b) Draw a line on the RH and LH tie rod and rack ends where
it can easily be seen.
(c) Using a paper gauge, measure the distance from RH and
LH tie rod ends to the rack end screws.
HINT:
S Measure the RH side and LH side.
S Make a note of the measured values.

(d) Remove the RH and LH boot clips from the rack boots.
(e) Loosen the RH and LH lock nuts.
(f) Turn the RH and LH rack end by the same amount (but
in different directions) according to the steering angle.
1 turn 360 deg. of rack end (1.5 mm (0.059 in.) horizon-
tal movement) = 12 deg. of steering angle
(g) Tighten the RH and LH lock nuts by the specified torque.
Torque: 55 N

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo