Service Manuals, User Guides, Schematic Diagrams or docs for : . Electronic Components Datasheets Passive components capacitors RG-Allen RG-Allen General Information

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document
RG-Allen General Information


>> Download RG-Allen General Information documenatation <<

Text preview - extract from the document
                 Aluminum Electrolytic Capacitors
General Information For Application
The following cautions must be observed when using electrolytic capacitors
1. Polarity:
   DC electrolytic capacitors are polarized. If used in reverse polarity, the circuit life may be damaged.
   For usage on circuits whose polarity is occasionally reversed or whose polarity is unknown, use non-polar
   capacitors.
2. Operating Voltage:
   Do not apply a voltage exceeding the capacitor's rated voltage. Otherwise, the capacitors may be damaged
   as leakage current increases.
3. Ripple Current:
   The ripple current on the capacitors should be at or below permissible level. Do not allow the current to
   pass the capacitors in excess of the specified ripple current.
4. Operating Temperature:
   The capacitors should not be used in other than the guaranteed temperature range. Usage at room temperature
   will ensure long life.
5. Leakage Current:
   The leakage current shall be within specified levels. When capacitors are at a lower voltage, the actual leakage
   current will be reduced proportionately.
6. Safety Vent:
   Case diameters of 6.3mm and larger for Radial types are designed with case venting, and case diameters
   of 8mm and larger for Axial types are designed with safety vent on rubber bung.
7. Soldering:
   (A) Be careful of temperature and time when soldering. Dip of flow soldering of the capacitors should be
        limited to less than 260



◦ Jabse Service Manual Search 2024 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo