Service Manuals, User Guides, Schematic Diagrams or docs for : . Rare and Ancient Equipment Rolsen DVD Сервисные мануалы RDV-630 1-1

<< Back | Home

Most service manuals and schematics are PDF files, so You will need Adobre Acrobat Reader to view : Acrobat Download Some of the files are DjVu format. Readers and resources available here : DjVu Resources
For the compressed files, most common are zip and rar. Please, extract files with Your favorite compression software ( WinZip, WinRAR ... ) before viewing. If a document has multiple parts, You should download all, before extracting.
Good luck. Repair on Your own risk. Make sure You know what You are doing.



Image preview - the first page of the document



>> Download 1-1 documenatation <<

Text preview - extract from the document

1. Precautions
Prior to shipment from the factory, the products are strictly inspected to conform with the recognized product safety
and electrical codes of the countries in which they are to be sold. However, in order to maintain such compliance, it
is equally important to implement the following precautions when a set is being serviced.


1-1 Safety Precautions

(1) Locations requiring special caution are denoted          (5) Observe that wires do not contact heat producing
    by labels and inscriptions on the cabinet, chassis           parts (heatsinks, oxide metal film resistors, fusible
    and certain parts of the product. When performing            resistors, ets.)
    service, be sure to read and comply with these and
    other cautionary notices appearing in the                (6) Check that replaced wires do not contact sharp
    operation and service manuals.                               edged or pointed parts.

(2) Some parts are critical for safety. Replace only         (7) 1) When a power cord has been replaced, check
    with specified part numbers.                                 that A mark is made on the cord, under strain, near
    Note: Parts in this category also include those              the aperture, and the flexible cord is subjected 100
    specified to comply with X-ray emission stan-                times to a pull of 40N for a duration of 1 second
    dards for products using cathode ray tubes and               each.
    those specified for compliance with various                   2) During the test, the cord shall not be displaced
    regulations regarding spurious radiation emission.           by more than 2mm.

(3) Use specified internal wiring. Note especially:          (8) Also check areas surrounding repaired locations.
    1) Double insulated wires
    2) High voltage leads

(4) Use specified insulating materials for hazardous
    live parts. Note especially:
    1) Insulation Tape
    2) PVC tubing
    3) Spacers
    4) Insulation sheets for transistor




                                                                                                                  1-1

◦ Jabse Service Manual Search 2026 ◦ Jabse Pravopis ◦ onTap.bg ◦ Other service manual resources online : Fixya ◦ eServiceinfo